Hot rolled nm450 steel plate manufacturer thicknes and width

Our quality control department will do inspection for details of the steel materials NM450 steel plate manufacturer before delivery. We would invite the customer side to attend the inspection together. If they can not come, we will also take rich pictures for them to check. Meanwhile, we will publish inspection report and send them the PDF version. Besides, we accept any third party inspection such as SGS, BV, etc. And our quality control department will support the third party to inspect the steel materials smoothly and try our best to deliver the qualified steel materials to customers earlier.

The pre cooling direct quenching and low temperature tempering of wear-resistant composite plate can reduce the quenching deformation of the workpiece, and the residual austenite content in the carburized layer can also be slightly reduced. The surface hardness of the hardfacing wear-resistant composite plate, NM450 steel plate manufacturer is slightly increased, but the austenite grain does not change. It is widely used in various tools of fine grain steel manufacturing.

P235GH steel material number under EN10028-2:2003 standard is 1.0345. This steel is a European pressure vessel steel. P235GH Mechanical properties: Tensile strength σb (350 ~ 480 MPa); Yield strength σs(215 MPa min.); Elongation ≥25%; Brinell hardness ≤105 ~ 140. NM450 steel plate manufacturer, P235GH steel chemical composition (mass fraction,%): ≤0.16 C; ≤0.35 Si; 0.60 ~ 1.20 Mn; ≤0.025 P; ≤0.010 S; ≤0.30 Cr; ≤0.30 Ni; ≤0.30 Cu; ≤0.08 Mo; ≤0.02 V; ≤0.02 Nb; ≤0.012 N; ≤0.020 Al; ≤0.03 Ti.

We provide customers with demand support and better serve them. We are committed to actively meet the needs of customers, always keep in touch with them in a timely manner, leave a good impression for customers, and make customers satisfied through our unremitting efforts. Customer satisfaction is our most basic vision, striving to become the best steel product service provider in the world